LOGIN TO YOUR ACCOUNT

Username
Password
Remember Me
Or use your Academic/Social account:

Congratulations!

You have just completed your registration at OpenAire.

Before you can login to the site, you will need to activate your account. An e-mail will be sent to you with the proper instructions.

Important!

Please note that this site is currently undergoing Beta testing.
Any new content you create is not guaranteed to be present to the final version of the site upon release.

Thank you for your patience,
OpenAire Dev Team.

Close This Message

CREATE AN ACCOUNT

Name:
Username:
Password:
Verify Password:
E-mail:
Verify E-mail:
*All Fields Are Required.
Please Verify You Are Human:

OpenAIRE is about to release its new face with lots of new content and services.
During September, you may notice downtime in services, while some functionalities (e.g. user registration, login, validation, claiming) will be temporarily disabled.
We apologize for the inconvenience, please stay tuned!
For further information please contact helpdesk[at]openaire.eu

fbtwitterlinkedinvimeoflicker grey 14rssslideshare1
Al-Arbi, Salem; Gu, Fengshou; Guan, Luyang; Ball, Andrew (2009)
Publisher: University of Huddersfield
Languages: English
Types: Part of book or chapter of book
Subjects: TL, T1
For gearbox condition monitoring, because the difficulty of sensor installation, it is a common practice to measure the vibration at a location far from the fault source. In addition operating the gearbox under different loads and speeds also produces the vibration signals with different components. The vibration measured in this way may be distorted significantly by the effect of signal transmission paths and the interference from other sources. The suppression of distortions is thus a key issue for the remote measurements based condition monitoring. In this paper, the influences of transducer locations and operating conditions on the vibration signal are investigated on a typical gearbox transmission system for the detection of the faults induced to the gearbox. The experimental study results show that the performance of traditional signal processing techniques is not sufficient to reveal fault detection information. However, the new feature from the spectrum of time synchronous average (TSA) signal is very effective in suppressing noise and hence leads to better detection of the local faults induced to the gear system.
  • The results below are discovered through our pilot algorithms. Let us know how we are doing!

    • [1] R. B Randall, Application of cepstrum analysis to gearbox diagnosis, Bruel & Kjaer, (1980).
    • [6] L. Mitchell. et al., Review of vibration analysis methods for gearbox diagnostics and prognostics, Proceeding of the 54th Meeting of the Society for Machinery Failure Prevention Technology, 2000, p. 623.
    • [7] R. B. Randall: A new Methods of Modeling Gear Faults, Journal of Mechanical Design Vol. 104 (1982), p.259.
  • No related research data.
  • No similar publications.

Share - Bookmark

Cite this article

Cookies make it easier for us to provide you with our services. With the usage of our services you permit us to use cookies.
More information Ok